Ferrari roof fans
Series with direct drive
|
|---|
| fans at manufacturer prices |
| up to ~300,000 m³/h |
| up to ~3000 Pastat |
| adjustable blades (vanes / wings) at standstill |
| Housing also available in stainless steel or special steel |
| Air directions B (pushing over the motor) and A (sucking over the motor) |
| ATEX possible |
Areas of application
- Agriculture
- Textile
- Ceramics, bricks
- Dust collection and filters
- Safe tunnel ventilation with tunnel fans
- Energy and environmental industry
- Pharmaceuticals and chemicals
- Cement, asphalt
- Oil, gas power plants
- Food, mills
- Marine
- Painting plants
- Wood
- Tobacco
- Filter plants
- Metal industry
- Burners
- Paper, nonwovens
- Glass
- Assembly companies
The housings are made of steel or stainless and special steels and are painted, galvanised or otherwise coated.
Depending on the design, the air flow over the motor can be suction or pressure.
Conveying temperatures are standard from -20 °C to +40 °C. If required, these fans can also be designed for operation at lower and/or higher temperatures.
Operation in potentially explosive atmospheres can also be realised without any problems after prior design.
Available accessories:
Flanges, swirl controllers, butterfly valves, louvres, sleeves, suction-side filters, vibration dampers, protective grilles, inlet nozzles, mounting plates, housing feet
- Ø 400-1000 mm
- to 34,200 m³/h free-blowing
- to 550 Pa
-
ET, TA (PDF)
-
AREA OF APPLICATION
For room ventilation, to create pressure equalisation between the inside and outside of buildings or warehouses. In order to guarantee perfect performance in both pressure and suction operation, it must be ensured that an air volume corresponding to the extracted volume can flow in.
-
DESIGN
Direct drive. This series is manufactured in two versions.
-
MOTOR
Three phase, 230/400 volts, 50 Hz, type V6. Other versions on request.
-
VERSION "A"
ET: Conventional shape of roof fan with base to facilitate installation. The casing has the shape of an inlet nozzle, which guarantees good performance data and a low noise level. Hot-dip galvanised finish and foul-weather bonnet eliminate the need for maintenance.
TA: Conventional roof fan shape with base to facilitate installation. The housing has the shape of an inlet nozzle, which guarantees good performance data and a low noise level. Hot-dip galvanised design and foul-weather bonnet in GRP make maintenance unnecessary.
-
VERSION "B"
ET: Basic version without base with pressure and suction side flange. Constructive without moulding of an "inlet nozzle" - the modified characteristics (see there) must be observed. Stove enamelled version with bad weather cover. Both versions are equipped with an impeller made of explosion-proof die-cast aluminium with 5 profile blades that can be adjusted when stationary.
TA: Basic version without base with pressure and suction side flange. Constructive without moulding of an "inlet nozzle" - the modified characteristics (see there) must be observed. Stove-enamelled version with foul-weather bonnet in GRP.
-
MOTOR
Three phases, 230/400 volts, 50 Hz, type V6. Other versions on request.